16' MasterView Pro Cable

16' MasterView Pro Cable

: IOGEAR

: 2L1705

The cables that you use when connecting your computer to our MasterView KVM switches play a very important role in the quality of the communication between the PCs and the MasterView unit. Our custom made cables are designed to provide the highest signal capacity along with the lowest signal loss....
$53.20
The cables that you use when connecting your computer to our MasterView KVM switches play a very important role in the quality of the communication between the PCs and the MasterView unit. Our custom made cables are designed to provide the highest signal capacity along with the lowest signal loss. What this means, to you as the consumer, is that you will receive the highest quality video output even in the higher SuperVGA video modes. An Average Cable Your average cable has one layer of shielding, a thin layer of mylar foil that has been cut into a very long and narrow, approximately one half of an inch wide, strip that is wound in a spiral pattern around the wires, also called leads, in order to reduce the cost of the cable. There are a few problems with this method of shielding a signal bearing cables, first and foremost among them is the fact that this wrapped foil method can leak RF (radio frequency) interference. Additionally the manufacturers of your average cables use very small wires to carry the

  • PS/2 equipped KVM cable
  • For use with MasterView Pro KVM switches
  • Has one male 15-pin HDB, two male 6-pin PS/2, and two audio connectors on the first side
  • Has one male DB25 connector on the second side
  • 10 feet long